Rechercher une page de manuel
snd_gusc.4freebsd
Langue: en
Version: 300367 (debian - 07/07/09)
Section: 4 (Pilotes et protocoles réseau)
BSD mandoc
NAME
snd_gusc - Gravis UltraSound ISA bridge device driverSYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:device sound device snd_gusc
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:
snd_gusc_load="YES"
Non-PnP cards require the following lines in device.hints5:
hint.gusc.0.at="isa" hint.gusc.0.port="0x220" hint.gusc.0.irq="5" hint.gusc.0.drq="1" hint.gusc.0.flags="0x13"
DESCRIPTION
The bridge driver allows the generic audio driver sound(4) to attach to Gravis UltraSound sound cards.The value of flags specifies the secondary DMA channel. If the secondary DMA channel is C, set the flags to (C | 0x10). For a sound card without the secondary DMA channel, the flags should be set to zero.
HARDWARE
The driver supports the following sound cards:- Gravis UltraSound MAX
- Gravis UltraSound PnP
DIAGNOSTICS
- xxx: gus pcm not attached, out of memory
- There are not enough memory to drive the device.
SEE ALSO
sound(4)HISTORY
The device driver first appeared in Fx 4.0 .AUTHORS
An Ville-Pertti Keinonen Aq will@iki.fi An Seigo Tanimura Aq tanimura@r.dl.itc.u-tokyo.ac.jpBUGS
Recording pcm sound data is not supported yet.Contenus ©2006-2024 Benjamin Poulain
Design ©2006-2024 Maxime Vantorre